Tap Needed

jecues · May 8, 2018

Im currently working on a Cheap Varner Cue and the pin is a 3/8-12 anyone have a tap for that for sale? Or know where I could find one. Thanks JIMM

ekb6760 · May 8, 2018

I could have used that very same tap. I am convinced it would have to be made by a machinist. In my effort to fabricate an insert, I discovered that the pin would screw into a plastic Cuetec joint protector (the long version, sorry no pic), even though the Cuetec pin is a 3/8" x 14. I hope this helps.

Jim Baxter · May 9, 2018

Change the pin

JoeyInCali · May 9, 2018

Jim Baxter said:
Change the pin

Or get a metal lathe with a thread gear .
I ran into a .350" 11tpi screw .
Did not need a tap to make a shaft.

Michael Webb · May 13, 2018

jecues said:
Im currently working on a Cheap Varner Cue and the pin is a 3/8-12 anyone have a tap for that for sale? Or know where I could find one. Thanks JIMM

I had Widell make mine years ago. It wasn't cheap.

ddcuerepair · Jun 12, 2018

http://cuefits.com/html_info/Taps-&-Drill-Bit-17.html
Here you go. They have the tap you are looking for.

ROB.M · Jun 12, 2018

Tap

If you don’t have a member login at cuefits, you can also buy from the cuefits Ebay store.
https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.com/ulk/itm/183254683564

Enjoy’

Rob.M

ekb6760 · Jun 12, 2018

ddcuerepair said:
http://cuefits.com/html_info/Taps-&-Drill-Bit-17.html
Here you go. They have the tap you are looking for.

Thank you. Looks like I'll be spending my next paycheck there! :dance:

Tap Needed

jecues

JE cues

ekb6760

Misplaced Texan

Jim Baxter

AzB Silver Member

JoeyInCali

Maker of Joey Bautista Cues

Michael Webb

AzB Silver Member

ddcuerepair

AzB Silver Member

ROB.M

:)

ekb6760

Misplaced Texan