I recently acquired a McDermott D-19 and RS-13. Both could use some work as described below. Looking for recommendations on who to send them to.
The D-19 has its dings/dents but I also found the butt end has about a 2mm warp that seems to be in the handle area. I'm thinking that it should be able to straighten it by replacing the handle but waiting to hear opinions first.
The RS-13 is near mint except for about a dime size piece of clear coat missing from the butt sleeve. Looks like near the rings in that section there may be air trapped under the clear as well. This cue has seen very little use and both shafts for it are like new.
Both cues I'm planning on refinishing.
The D-19 has its dings/dents but I also found the butt end has about a 2mm warp that seems to be in the handle area. I'm thinking that it should be able to straighten it by replacing the handle but waiting to hear opinions first.
The RS-13 is near mint except for about a dime size piece of clear coat missing from the butt sleeve. Looks like near the rings in that section there may be air trapped under the clear as well. This cue has seen very little use and both shafts for it are like new.
Both cues I'm planning on refinishing.