4 Sets of Radial Pin Carbide Sanding Mandrels.

shamadam

AzB Silver Member
Silver Member
All set's have been dealt away. Thanks for the interest.
 
Last edited:

Someoneelse

Registered
830 mandrel

830 mandrel, how long have you used it? Where are you located? What are they, looking for 3/8-10
 
Last edited:

shamadam

AzB Silver Member
Silver Member
830 mandrel, how long have you used it? Where are you located? What are they, looking for 3/8-10

I have never used these Mandrels. I received them with the Hightower Deluxe lathe that I purchased last year. I'm not going to be building cues for a while, and if I do, I'll be using other pins. I'm in Willoughby Ohio. Just east of Cleveland by about 1/2 hour. I do not have any other pin mandrels at this time. The cue maker I purchased the lathed off of used them, but they don't look like they were used very much. They are used for sanding your finish down to size. When your finish is sanded flush to the mandrel, then it's to size. Thanks.
 
Top