Go Back   AzBilliards.com > Main Category > Main Forum
Reload this Page Trying to find the maker of this cue...
Reply
 
Share Thread Tools Rate Thread
Trying to find the maker of this cue...
Old
  (#1)
Lance Link
Banned
Lance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond repute
 
Status: Offline
Posts: 297
vCash: 500
iTrader: 0 / 0%
Join Date: Jul 2010
Location: Rochester, New York
   
Trying to find the maker of this cue... - 07-01-2010, 06:03 PM

I've had this gem for a while, and have finally decided to get serious about finding out who built it. I've looked all over the internet and still cannot figure out who made this cue.
Uniloc joint, 13mm, "Bushka" style rings. I can't tell what type of wood(s) are used in this cue, and my best guess on the "white" parts is synthetic ivory. I'm a wood-to-wood guy, but this cue hits pretty solid.
Any help would be greatly appreciated...
Attached Images
     
  
Reply With Quote

Old
  (#2)
12squared
AzB Gold Member
12squared has a reputation beyond repute12squared has a reputation beyond repute12squared has a reputation beyond repute12squared has a reputation beyond repute12squared has a reputation beyond repute12squared has a reputation beyond repute12squared has a reputation beyond repute12squared has a reputation beyond repute12squared has a reputation beyond repute12squared has a reputation beyond repute12squared has a reputation beyond repute
 
12squared's Avatar
 
Status: Offline
Posts: 5,832
vCash: 4100
iTrader: 137 / 100%
Join Date: Jan 2005
Location: Fort Collins, CO
   
07-01-2010, 06:40 PM

It may be an old Woody Woodworth cue. Contact him to see: http://www.woodworthcues.com/
  
Reply With Quote
Old
  (#3)
cue fix
Will "MONSOON" & SEARING!
cue fix has a reputation beyond reputecue fix has a reputation beyond reputecue fix has a reputation beyond reputecue fix has a reputation beyond reputecue fix has a reputation beyond reputecue fix has a reputation beyond reputecue fix has a reputation beyond reputecue fix has a reputation beyond reputecue fix has a reputation beyond reputecue fix has a reputation beyond reputecue fix has a reputation beyond repute
 
cue fix's Avatar
 
Status: Offline
Posts: 803
vCash: 500
iTrader: 22 / 100%
Join Date: Mar 2008
   
07-02-2010, 09:51 AM

That is what I was thinking as well.
  
Reply With Quote
I'll have to keep looking...
Old
  (#4)
Lance Link
Banned
Lance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond repute
 
Status: Offline
Posts: 297
vCash: 500
iTrader: 0 / 0%
Join Date: Jul 2010
Location: Rochester, New York
   
I'll have to keep looking... - 07-02-2010, 07:41 PM

Thanks for your suggestions. I emailed Woody Woodworth a few pics and asked if this might be his. He stated that it was not, and that there were a few people out there trying to mimic his "W". He noted that his "W"'s have wings on them.
I wish I could post better pictures with close ups of the inlays. I've gone over this cue very carefully, and there's not a doubt in my mind that these are inlays. A couple of players in my league looked it over pretty close as well, and they are of the same opinion. One even mentioned that uniloc and radial joints have to be very precise when they are installed, and the uniloc pin on this cue lines up perfectly with the shaft.
It's a shame, because the person who made this has done some nice cue work to be very proud of...
  
Reply With Quote
Don't know how much this might be helpful...
Old
  (#5)
Lance Link
Banned
Lance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond reputeLance Link has a reputation beyond repute
 
Status: Offline
Posts: 297
vCash: 500
iTrader: 0 / 0%
Join Date: Jul 2010
Location: Rochester, New York
   
Don't know how much this might be helpful... - 07-04-2010, 07:17 AM

The person I purchased this cue from online listed it as a "Wolf" cue, but I've looked and can't find a cuemaker with that name. I don't know if 'Wolf' could be someone's apprentice or not. Any help identifying this cue would be tremendous...

Last edited by Lance Link; 07-06-2010 at 04:57 AM.
  
Reply With Quote
Reply

Thread Tools
Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity (Lite) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.