Ok, so i'm setting up my GC3 using RKC'S installation thread but i hit a road block, i'm trying to level the frame from side to side using a four foot level and a calibrated Machinist level, i get the Bubble on the M Level dead centered but when i push up and down on the table to check for rocking i find one leg is sitting lower that the other one, when i take up the slack on the lower leg i lose the bubble.
I even went to 1/4 turns and i still lose the bubble but the Rocking goes away, get the level back but the rocking comes back.
Now, i have a slope in my Garage but that is from the Head to the Foot not side to side, i seemed to of corrected the head to foot slope by having one side a half inch higher then the other side.
All of the Frame/stretcher bolts and screws are all tight, I started the side to side level with the Adjustable legs at the lowest setting.
What am i missing ?
I even went to 1/4 turns and i still lose the bubble but the Rocking goes away, get the level back but the rocking comes back.
Now, i have a slope in my Garage but that is from the Head to the Foot not side to side, i seemed to of corrected the head to foot slope by having one side a half inch higher then the other side.
All of the Frame/stretcher bolts and screws are all tight, I started the side to side level with the Adjustable legs at the lowest setting.
What am i missing ?