Centralizing the router mount hole to the width of the mount block, using a Universal mic to check the wall section.
Flipped block over , leaving the same face against the vice jaw, so only need to find the hole center, in X (long axis). Y has not changed, C' bore to
Spot drill and drilling the capscrew holes. Drilled from under side, as that is the important side to match Taig Slide T slot.
Checking the fit of the Taig slide into the bottom side of router mount.
Centralizing the router mount hole to the width of the mount block, using a Universal mic to check the wall section.
Making-Router-Mount,1st set up for squaring block from turned reference face.
Making router mount 5
Making router mount 4
conetip

Centralizing the router mount hole to the width of the mount block, using a Universal mic to check the wall section.

  • Media owner conetip
  • Date added
There are no comments to display.

Media information

Album
Radius-Trimmer
Added by
conetip
Date added
View count
349
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top