Recent content by 91design

With snooker felts you should use tacks and not staples that could cut through the felt?

Nice to talk to you too, martin :D I used this tool to create new countersinked holes on a GC IV Brazilian Slate, so it should be good with pennsylvania slates too.

I used this ceramic spheric abrasive drill bit ; it worked like a charm(you can't even spot the difference between the originals and the handmade holes), you only need to pay attention when you start to drill the countersink because sometimes the bit tend to slide. The manufacturer is wolfcraft...

I sent you a pm. It's not a problem if the shipping cost exceeds the table value. In italy is nearly impossible to find a brunswick anniversary, so it's ok to pay a little more.

Could you ship it to europe?

Russ honestly I think that you would have done a better work installing the cloth yourself with the support of Simonis DVDs.

Maybe I'm wrong, but it seems that cloth on the rail isn't installed correctly... How did your mechanic level the table?

Also you would like to avoid using the exact same pockets' specs as a Diamond BL; the Diamonds have a deeper pocket's shelf, Mark (and I think Glen also) cuts the subrails at a 13° Down Angle on tables with shallow shelves (like a GC) Good Luck;)

Artemis intercontintal are k55 profile cushions, but as mark stated in the comment I quoted before the Artemis have a longer nose, so if you want the best playability, the one as close to a blue label diamond, as stated by mark again, you need to correct and calibrate the subrails. But there is...

Also it depends if the gcIII you bought is first production or not.

Artemis inteecontinental cushions won't fit without modifying the subrails profile. I'm nowhere near a mechanic, so it could be the case that I'm wrong, but I read every single thread on this forum about rails and subrailsand that was the answer that was given any single time ;) Mark Gregory and...

This was my initial intention, but the more I read the more I realized that without the exact specifications and without the right tools to correct and recalibrate the rails(because of inconsistency of Brunswick manufacturing), the work would not have been what I wanted. Yeah I know that the...

Hi all, I am thinking about replacing the cushions on my Gold Crown IV in the next months and having the rails extended and recalibrated. I have probably read every topic on this forum concerning the issue, and I have come to the conclusion that it is not a job I can do alone, I do not have...

This should be good