Recent content by Afrevele

I’m not above having some fun or joking around. But when like you said, Skins, when you are looking for a solution to a problem it’s a different thing. If you look back at the beginning he fired I fired back. He should’ve left it alone at that point. Anyway I found my answer elsewhere. Simply...

Then what are you doing here? Obviously they’ll let an idiot in Who has nothing better to do than troll peoples posts and make stupid comments. You must not know anything about cues and only came here to post a juvenile response.

Nice, maybe you should try growing up. If I wanted a smart ass answer I would’ve asked for it.

I have a Meucci DH-3 that the shaft insert slightly turns (a little less than 1/8”) when I am screwing it onto the butt. Any advise on how to remedy this is appreciated!

Not sure I fully agree with the value stated here. A brand new 95-31 goes for ~$1200. So how is it that you are saying it’s worth half that? Don’t follow the logic? I understand that the maple forearm Meucci Original version is more desirable and hence valued more but Can’t see this one being so...

Know this probably has been done before but... Looking for a value for this stick. It is in immaculate condition. Both shafts look like they’ve only been hit a few times. The stick is signed by Shannon “The Cannon” Daulton and Robert Meucci. Not sure what the #5 is after his name? Thoughts? Any...

I have this same cue with the David Howard at the bottom of the butt ring. As you stated, the By Meucci isn't present on my cue as well. I talked to Meucci after sending pics of the cue for authentication and they said that it happened sometimes when the stamp was applied.

Yea if you look the stamp is at the bottom of the ring so it was definitely off and not a result of a repair or cut off of the ring.

The butt is the standard length, I guess you can order a shorter shaft if you want to.

The guy at Meuccisaid that the butt ring is short so sometimes when they stamp it it gets cut off. He said it’s not that uncommon.

Anyone know anything about this case? I was told Bob Meucci used to work for them. Just wondering if it is anything worth hanging on to.

Got a reply from Meucci and talked to somebody over there. They said since the butt Is so short sometimes they miss and part of it can get cut off. As far as the shaft ring work goes he said those things are really hard to get straight and sometimes in production it can offset a little. One of...

So I picked this Cue up for $80 yesterday. I’m fairly certain it’s a DH3 Meucci. Only a couple of things that are not there that make me wonder a little bit. There is no by Meucci under the David Howard lettering. Also there is a slight difference in the ring work on the shafts. They are two...