Recent content by Ccarroll

Selling Hightower Lathe. All pictures can be found on cueman website. Serious inquires only please. Asking$ 2000 Message me your phone number for additional information.

Match http://youtu.be/SYmsptO3Q7c Alcano vs Souquet world 9 ball 2006 Alcano soft breaks flawlessly the entire match

game I don't think he did. I didn't see him even talk to anyone on the 9ft table side. he walked around and left

Seen him trolling recently in Breaktime Billiards in Wilmington NC

Balls Pm sent thank you

Tip Talk to chris Hightower The shaper shown in the link resembles chris hightowers original design

I used indoor/outdoor hybrid carpet without padding. It works great. That kind of carpet is made with moisture barrier properties. I covered an 15x19 space for roughly $ 170 Also taped it down with double sided carpet tape.

I don't think I mentioned sand paper.

Ok. Thanks guys.

No ribbon when I cut that one. Just found out the guy bought it on amazon. So that answers any doubt.

I have used a razor blade before to get the tip flush. However I'm comfortable using bits to get the tip flush. My "lathe thingy" is dialed in perfect. Also I like to trim the tip towards the ferrule not away from it with a razor blade. Either way works. I just do it my way. Believe it or not...

A RH tool bit is a type of tool used in a lathe. If you own or have ever seen a lathe with a tool bit in the tool post you would know what I mean. :grin-square:

Sounds good to me. If it were my cue I wouldn't mind. I play with ultra skin tips. The owner of the kamui wanted the kamui so I installed another kamui.

That's my new policy. :)

Anyone know where I can find a 2015 US Open 9 ball shirt ?