Recent content by cueguy

I heard Kamui is raising its prices on July 1st. Does anyone know how much?

BSI has a glue remover called un-cure. It works good and I used it yesterday at a tourney.

Thanks for all the ideas. I tried to get him to just keep the autographs but he doesn't want them. Thanks.

I have a friend that has multiple signatures on different Jacoby cues (not Jacoby sigs) that he would like removed. Things like Nick Varner, etc. Alcohol doesn't seem to even affect it. Any ideas to remove it without messing up the finish? Thanks,

I have a friend that has a beautiful Pat Diveney cue and would like any information and possible value if possible. I did leave a message on his facebook page but haven't heard anything yet.

OK - he decided 3/8-10 would be good... ;-) Does anyone have a couple of those in G10? Thanks.

I had not seen one either but it was a special request and I told him I would try. Thanks!

Anybody know where I can find a couple 5/16-18 pins made of G10? Thanks!

Dave, Thanks for this! It seems that was the issue. I was kind of worried about pu9tting it directly over the joint but that is what it needed. Thanks again!

I just got an induction heater and trying to use it to remove a 5/16-18 pin (he wants radial). I have used it many times up to a min each to where it smokes and set it down and try to unscrew the pin immediately to no avail. Any hints on how long this takes to get it hot enough to actually...

That's great. I appreciate it. Larry

Thank you Sir! Larry

How far can a Predator Vantage be SAFELY turned down? He wants it at 12.6. That be OK? Larry

Going to have to do a stack leather because the channel is too deep.

I hate these rubber power wraps. What are some good ideas to remove these pieces of junk? ;-) Thanks, Larry