Dave38's latest activity

Where did boogie man bad mouth a product? he certainly didn’t in that quote.

only if he fell asleep about 20 minutes into it. I charge $75 + with me supplying the blank, with ALL the prep, and I do move slow...

Can't beat the price. 4 hrs??? What, is he taking 3 half hr coffee breaks, surfing his phone, going in for a colonoscopy during the...

I think you're reading to deep into my posts. Just a few simple statements....nothing combative like your post. However, you are correct...

I ALWAYS sand any tip including kamui clears to INSURE that the bottom is PERFECTLY FLAT! Many tips are NOT and that leads to a tip...

PROCEDURE FOR RADIAL® PIN SHAFT INSTALLATION 1. CENTER DRILL TO A 5/16 DIAMETER 2. DRILL .312 DIAMETER 2.300 3. TAP WITH RADIAL® TAP...

You might just reach out to Ariel, he's pretty responsive and may be willing to just tell you what material he uses...

I tried to post the video but the server said the file was too large so I'll try to do another one that's shorter I guess, but I can't...

the .550" cap is so when done, you don't see a spiral from the threads. It's a full circle. if doing a fully threaded plug, it will look...

I use an insert cutter made to cut aluminum and run it about 900 rpm. Cuts smooth. Then I center drill and drill/bore and tap.

Just my choice I do the internal threading after the insert is installed. I do all my inserts like that.

Buy brass bar and drill and part off whatever size you need.

Okay, was wondering if you had a way to make an allen wrench fitting on them, like cuefits had on their POM fittings.

Nice, how do you tighten them down on the cue?

I'm a hobbiest. I use those same nylon bolts to make extension inserts for my cues. I cut the bolt head to the right size, then use the...