Recent content by Goody04

I did some research into what Rheostat is and from what I gather it is a variable resistor that controls the flow of current. I am by no means an expert with electricity, but I have this particular light connected to a regular flip switch. These lights are dimmable through 0-10v connection...

Over the past few months, I’ve been on a mission to upgrade my pool table setup. I went from an oversized 8ft Gold Crown IV to a 9ft Diamond, and once that was in place, I knew the next step had to be lighting. For years, I was relying on a basic LED shop light from a big-box store. It worked...

hey, How much space did you allow in between your light and the louvers? I know you did not use LED panels for your build. I am currently building a light and didn’t know if the LED panel could sit on the louver or if I should have a spacer in between. Any info is helpful, thanks.

Hey, I am looking at your project and had a few questions. Did you buy 2x4 parabolic louvers then cut them into 2x2 sections, or did you leave them intact. I was able to find 2x4 LED panels from Sunco that are able to produce up to 9000 lumens, do you think these will be sufficient?