HoustonInt's latest activity

Been having much better results now. I replaced the factory ferrule on my cue with a new Tomahawk ferrule.

Dave Jacoby started doing repairs on cues in 1982. With his son Shane, on a small lathe he purchased from Viking cues, they began...

If I may and Kim knows. You have to be REALLY REALLY careful on these. If you look, the picture says it all.

SOLD ~~~~~~~~~~~~~~~~~~~~~ These came with a lathe that I recently bought and I don't use these sizes. 5/16 x 18: 1 pin & 17...

I thought I would update this seeing McDermott has upgraded thier internal design. So if you work on one, it could have either style...

1- Joe Porpers Creative Inventions. I think it's a medium tip. Tiger products would know better. They made them for Joe before anyone...

I purchased an older Porper lathe and it came with some supplies including some older tips that I did not recognize. Does anyone know...

Will do and thanks! Sent from my iPad using Tapatalk

Good enough for me

Check the power feed. Make sure when you pull and push the big wheel it stops or starts. Just make sure is lubricated and cleaned.

Hello! I've been doing cue repairs for the past 8 years on a Mid-American and recently purchased a Porper B lathe. The guy I purchased...

I had an idea and decided to try an experiment. Thought I would share. I have seen some great seamless ferrules. Most people say use...

Pred blank

I’ve had very good luck with DAP adhesive for difficult ferrules. Sent from my iPad using Tapatalk

I sold the entire shop to a local fella today.