I purchased several new cues recently and keep them on the wall in a vertical rack. The bottom of the cue is supported by the lower shelf of the rack. The top of the cue fits inside a hole for each individual cue. I believe this is typical in billiard parlors.
The question is will this cause...
Does anyone know if storing a two piece cue in a standing rack tend to warp the shaft? The rack I have is 58" high and the end of the cue stick is about 1" higher than the top section of the rack. Should I disassembe the cue or is it ok to leave it in the rack? Thanks.
GC III VS GC IV, Which to buy?
Thanks for the info. I am about to buy one of the two and was hoping to find out from someone, the differences and is the IV worth more money??