Mike Rys's latest activity

  • M
    Mike Rys reacted to Sheldon's post in the thread Masse cue with Like Like.
    AI is just a tool. It can dig through more sources in seconds than most of us would in an hour, but you still have to use your own...
  • M
    Mike Rys reacted to Kim Bye's post in the thread Live threading bits. with Like Like.
    Live threading on the lathe.
  • M
    Mike Rys replied to the thread Live threading bits..
    I didn't say it didn't rotate. I said it didn't need to be continuous. With an A axis, a 60 degree V bit and a few Lines of Gcode, you...
    • Screenshot_20260309_003221_Gallery.jpg
  • M
    Mike Rys reacted to erriep's post in the thread Masse cue with Like Like.
    weight & stiffness. a very heavy butt with a shortened (carom or conical) shaft & a strong ferrule will do the job. Elkmaster tip...
  • M
    Mike Rys replied to the thread Live threading bits..
    It doesn't need to be continuous to thread.
  • M
    Mike Rys replied to the thread What pin is this.
    If you download the Thread Pitch application to your phone, you can use it to measure the thread pitch. It's accurate enough to...
    • Screenshot_20250103-002705_Thread Pitch.jpg
  • M
    Mike Rys replied to the thread Live threading bits..
    If you have an A axis, I would add a 1/4 inch 60 degree V bit.
  • M
    Mike Rys reacted to Kim Bye's post in the thread REBUILD A CUE with Like Like.
    A cue can't easily be taken apart and put together, it's not LEGO.. Can you replace individual components in a cue? To a certain extent...
  • M
    Mike Rys reacted to cueman's post in the thread Want to start in basic shaft repair. with Like Like.
    This is what I think would fit your need. https://www.cuesmith.com/the-mid-size-cue-smith-with-sliding-headstock/
Show older items
Back
Top