Recent content by nathan79

Wish I had a rfid chip in my cues for sure. I also wish I had a gps tracking device hidden in my cue case that I could track with my phone.

Spartan, in an attempt to be vague, and not tip off the individual that has them my post may have been misleading. My cues were stolen out of my vehicle about two months ago. Through research on the Internet I now know who has them, but I believe they purchased them from the actual thief. I will...

Thanks bbb, I will get them back one way or another, I'm just hoping it's the easy way. I don't think the individual that has them stole them, but if he lies to the cops and says he doesn't have them he is just as guilty as the original thief In my book

I didn't think I did bbb. That is the reason for the lack of details in my post regarding what kind of cues, who the individual is- etc etc

Unfortunately I did not. I purchased one of the cues from jjcue about 5 years ago, maybe they can come up with a receipt for me. The other one was purchased about 14 years ago and a receipt is impossible. Both are limited editions, so that might help my cause

I had a couple of cues stolen from me about two months ago. The good news is I have put in a lot of time on the net, and now know exactly who has them. I don't think this individual stole them though. I feel bad that he will be out the money, but they are my cues!! I am concerned that I can't...

Thanks Paul that was valuable information. The last thing I want to do is destroy that wood in the beginning stages. How would you recommend I turn it? My dad is a blacksmith and knifemaker so I do have access to a drill press, belt grinder, bandsaw, and other equiptment.

the blank measures 1.5"x1.5"x18" so I will end up needing to add a piece where the wrap will go. Hopefully I won't have to core it this way.

I only plan on building one handle Newton, so don't want to get too involved in cuemaking. I have a feeling it is going to take me months to complete. All the inlay work will be done by hand- and I have never done this before. The more I think about it the more nervous I get, but no turning...

Thats what I thought. I don't have the equiptment to do it right so off it will go. I don't plan on making the shaft either, it will be Predator or OB2

Yesterday I ordered one of the turnable blanks offered here on this site from Bell Forrest. I have never even dreamed of making my own stick until I saw that maple burl. My old high school buddy's dad has a wood lathe and said he would help me turn the blank. The only thing I am scared of...