Paul_#_'s latest activity

I've replaced a bunch of cynergy ferrules. They tend to deform. I am not impressed with the design or quality of them.

I owned a 9k and a K-Series Classic which covers two of those construction methods. Didn't notice any difference between them with the...

Below are Predator's description of butt construction using C4+ (4-piece core), C10+ (10-piece core), and P3 (30-piece core). (EDIT...

- - - - - there was no good reason for hitting the balls without a tip on the ferrule.

The 10.5mm Cynergy cue tip popped off playing and I hit a couple balls with it deforming the ferrule. I sanded it so that it works but...

How hard is it to replace the ferrule on the Cynergy? Does the ferrule you use look like the $5 ferrule Rhino sells?

Good evening folks. I recently ordered a Rhino Eclipse II "Noir" cue, with a 11.8 carbon shaft. I was looking forward to posting a full...

Anybody try them . And if so much difference than the regular rhino shaft

After going the route of cheap CF shaft to start with and then getting some mid-priced shaft to end up with an expansive shaft, It would...

The Revo 12.9mm I was used to the 12.75 314 shafts even though some of them are down to around 12.5mm from cleaning and sanding over the...

I contacted Rhino earlier this week when they 1st sent the email introducing the "must' shaft. Heres the questions & replies...

I run a few tests 1. put a CB on the kitchen line frozen to the rail and shoot with side spin parallel to the rail and try to pocket...

Another explanation for why gluing the Kamui clear tip to the Revo vault plate fails is that you need to glue the vault plate to a...

Out of sheer curiosity, I just bought an Evo decal cue from their Royale series (on the right, in case it wasn't obvious, lol). $104...

That's a good point. I deleted that post --- no sense helping a company's fraud.