Recent content by QC Cue

Looking for Gilbert ivory/ebony ring work joint protectors for 1 butt and 2 shafts

Looking for a Richard Chudy cue…who has one for sale?

I am looking for a Durbin cue with the G10 pin.

Jim Vest custom wrap less cue with "like new" Predator 314/2 thin ring shaft. $450.00 or open to trade offers. Looking for old McDermott D-Series cues http://www.ebay.com/itm/271761224860?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649 Thanks, Dan

SOLD. I will buy it. Please PM me with details.

I have a McDermott D-Series custom which is a gray stained D-Series cue with no points and a D12 butt and D12 ring work with a rare 31.5" shaft. I would trade this cue and a $100.00 for your BK3 and weight bolt set. That's is a pretty straight up deal.

I have an original Tiger Ultra X shaft that is a 5/16 x 14 piloted shaft with a single silver ring that I would trade. It has a slight taper roll but in really good condition.

SOLD. PM me on how you want me to pay and shipping instructions.

Please PM me what prices you want for each of these shafts or a price for all three shafts.

Is this a flat face 3/8 x 11 pin? I have a Durbin with a 3/8 x 11 G10 pin same as the Southwest pin thread but want to make sure this is a flat face joint set up.

I'll take it for $375 shipped. Please PM directions

Diveney custom hustler with two shafts. This cue is signed P.Diveney 06 on the butt cap. It is killer cocobolo going into birds-eye maple with a small ivory diamond in-between the bottom of each cocobolo point. It has a snake wood butt sleeve guarded by fancy ringwork that matches the joint and...

I will take 2 boxes too. PM me the details

What type of cue is the 5/16 x 14 shaft for? I have a test hit only Schon IV shaft with an ivory ferrule and a Moori medium tip. It is in "like new" condition and I would sell it for $150.00 plus shipping.

Stream My stream is very very very slow. It pauses every 30 to 35 seconds and pauses for about 20 seconds then continues and then starts all over again?