Recent content by Scott Behrens

I bought a used gecko g540 but ended up going a different route for now. If anyone is interested, i'll sell it for 210 shipped. Thanks. If I understand correctly, it is rev8 as it has trim pots on the motherboard

deal. i'll send pm.

I believe they're 115 on AliExpress. Not sure on Temu. I purchased one from Ali and have never used it. I'd consider selling but would be looking for very close to new price. Thanks.

You're looking for something like this?

Thanks for the thoughts. I've made some improvements without spending too much. The treadmill motor proved to overheat so i switched to a makermotor with power supply and used a HF ammo tin to get the electronics enclosed. I purchased a 3d printer for the kids that proved very helpful as well...

Thought it'd be fun to see if I could cheaply build myself a shaft tapering machine. its not perfect and needs some improvements, including a taper bar with a spring slide to follow the taper but it works. Thought I'd share that this can be built fairly cheaply. I had the trim router. Pulled...

still available These are still available. Thanks.

Headstock and motor are sold. QCTP is still available.

tulipwood I have 1 piece I was planning to keep but I may be willing to part with it if you haven't found any.

RAT (Ryan A Tweeten) Curly Maple Pool Cue with Joint Protectors - $240 shipped Preowned and has some nicks but a very nice functional cue. Curly Maple forearm and Butt Sleeve. Rings at butt and both sides of the joint. Comes with joint protectors. It is 19.3 ounces butt is 15.4 ounces shaft...

the pictures the pictures

All SOLD. Thanks. 1.5 x 1.5 x 18" The few I measured were just under 1.5 inches. $25 per piece for choice, plus shipping. or buy all 20 for $400 shipped. I did notice one that had a check in it so I'll take another look at these and update the post. I will update the thread as pieces are sold...

Taig compatible TS Engineering QCTP Set with 4 tool holders. Used but in good shape $115 shipped to continental US. Pictures below. The Dayton 3m580 AC motor, Taig headstock with Taig Pulley Set installed that was posted is sold. I'm not on here often so email me if you need to get my...

Its a nice cue. The larger shaft is all but straight. The smaller shaft, has about an average taper roll. Probably moves about the thickness of a business card.

Very nice pieces of wood. Cocobolo with birdseye/curly maple wrapless handle. 8 maple window rings in lower 3 positions. Plain black joint. 3/8-11 brass pin. two shafts, one with ivory ferrule. I bought this used and did notice that the ivory ferruled shaft has been screwed on a 3/8-10 at...