skor's latest activity

there are lots of reports about cracking ferrules and many videos that show replacing them. I have a Cyenergy that is only lightly...

Nice!!

Might be a difference in the stiffness of the hit, but you’ll have to hit with all of them with the same shaft snd tip to see if there...

Well done and congratulations to Amoroto. Too bad that it collided with big tournament in the USA and most western big guns didn’t made...

Thank you. Here is the Revo 12.9 with the Mezz pad and a G2 medium

Probably the best bang for your buck, and you can get it on temo for less that a $100, I would have gotten one if I didn't already have...

The biggest advantage for dedicated jump cue with modern jump cues is that they are 3 piece cues and longer compared to the jump section...

You don't have to do them all, but all are good to test deflection. The standard test needs a more scientific tools to see the results...

I run a few tests 1. put a CB on the kitchen line frozen to the rail and shoot with side spin parallel to the rail and try to pocket...

The Revo 12.9mm I was used to the 12.75 314 shafts even though some of them are down to around 12.5mm from cleaning and sanding over the...

After going the route of cheap CF shaft to start with and then getting some mid-priced shaft to end up with an expansive shaft, It would...

That's a great tip job for no lathe. I have a lathe and it's somewhat easy, but for no lathe, you should be proud of your work.

There shouldn't be an issue gluing the Kamui clear tip directly to the plate, just like there isn't an issue with other shaft's plates...

I think there is an issue with the material that the Predator Revo plate is made of. As I really didn't like the tip that I have...

I would love to collect a few cues from this line.