Recent content by str8shooter

Awesome player or collectible cue with no waitlist.

I'm in need of some room in my cases and would like to sell one of these cues. 3-06 Loaded Black creek,birdseye and ebony that's been played with some wear.Finish is pretty nice with some popping of rings,a few nicks and scrapes,wear on the leather wrap and butt cap,looks like one of the...

1.770 just measured an old one

Not to bad of a job unless the bearing wore out the spindle. I purchased one year's ago from porper and it was around $200.00 and the bearings around $50each.I found old stock bearings on Ebay for $15 each last year.It's a poland bearing 62092rs . The spindle on my last One was a little loose...

Private message sent

I'll take it

Reduced $275 shipped

no longer available

Cleaning out my case of cues I made in the last 2 years and don't shoot with. Cue 1 : Brazilian Rosewood and Curly maple wrap less cue.Nickel silver rings A,B&E and C&D rings are Rosewood.3/8-11 brass pin.18.4oz total/59-7/8" overall.(3.7oz maple shaft@29-7/8"Shaft,12.7mm)(14.7oz@30"Butt).Very...

very reputable maker....wow

We made a nice holding fixture that was around 2'x3' that we held down electronic component boards,that we trimmed with a lead trimmer after it ran through a wave solder machine.We used a large shop vac with a foot switch and it worked great.

Simple question..you guy and girls turn it into whatever.I needed a well deserved laugh and got it.and thanks again.She can read it.She can have the cue and the case.Got a Lawyer and so does she.Whatever happens.. happens.Not looking for legal advice,in fact the best advice I heard was the race...

yea.she plays very well for a girl.

Now that all the emotional marriage stuff is over and gone its time to move to the business end of things.

Thanks everyone for the input,I got what I wanted out of this post.A well needed laugh:smile: