Recent content by Uncle Rico

It is not just me, although top of my game is not a phrase I have used in a long time :embarrassed2: But there is a huge difference in play when i use the other 13mm shaft shaft. I am just not a fan of the 13mm and prefer the 12.5mm on the shaft that does not play so hot. I have replaced the...

What would cause a shaft to start to play bad after 12 years? There is no obvious signs of damage and a newer tip which has been replaced but I am still having issues. I do have a spare shaft purchased at the same time and it still plays solid but it is a larger diameter than the shaft I usually...

That's bending the cue ball

I personally love short pockets. I find that with deep pockets, my balls just kinda hang on the edge and never reach the bottom of the pocket. The shallower the pocket, the quicker my balls hit the bottom. My instructor once mentioned that if I would move up from a 57.5" stick to a 60" stick to...

i will take number 26

36 please.

I tried two different kinds of rubber cement-both failed. They would not adhere to the smooth metal even after I cleaned it. Gave in and super glued them and of course that held tight....I will see what happens in the future whenever I need to change them again. Thank you for your suggestions.

I am going to try the rubber cement. I will let you know if it works. Thanks for your help.

There was no backing and they did come in a little baggy with all 4 pieces but without the instruction sheet like you would see in the advertisement photo. I began by looking for a backing to peel off because that's how I thought they were supposed to be, but it is just backed sandpaper. Must...

Must be a generic set then. There is no adhesive on them.

What glue works the best for glueing in the refill abrasive disks? From another post on here I tried Elmers but that didn't work. After the glue dried it just slipped right off. I didn't want to use super glue because I was afraid I would never get it clean enough if Iever needed to change...