M manopr350 AzB Silver Member Silver Member Dec 25, 2025 #1 Is there a way to properly remove “skid” marks/scratches from a carbon fiber shaft? “Skid”= upon stroking the shaft contacts the edge of the table.
Is there a way to properly remove “skid” marks/scratches from a carbon fiber shaft? “Skid”= upon stroking the shaft contacts the edge of the table.
Kim Bye AzB Silver Member Silver Member Dec 25, 2025 #2 A picture helps a lot.. If it's nick in the shaft, that's permanent, so it's hard to say without seeing a picture of the actual shaft.
A picture helps a lot.. If it's nick in the shaft, that's permanent, so it's hard to say without seeing a picture of the actual shaft.
