Cue Companion Lathe by Unique Products.. Nice repair or starter lathe.
- Thread starter bigdogk9
- Start date
If I remember you need the small chuck to do tips and ferrules. The large chuck won't go small enough.
......
Yes it will.
Pictured is a thin wall 12.75 collet with shaft in the chuck. Still has room to tighten up more.
No problems with the thicker collet pictured.
If you want to put a small diameter Shaft in you will differently need the thick collet
Thanks for you help
Yes it will.
Pictured is a thin wall 12.75 collet with shaft in the chuck. Still has room to tighten up more.
No problems with the thicker collet pictured.
If you want to put a small diameter Shaft in you will differently need the thick collet
Thanks for you help
Attachments
Last edited:
Jesse Gilbert
Banned
My large chuck won't hold a shaft.
With use of those collets. Take the shaft out of the collet and see if it works. Mabe billiardbum will chime in and she'd some light.
Last edited:
I believe it's normal for that lathe. It has delrin jaws. I also remember them using masking tape as a type of collet. Once again hoping for billiardbum to chime in.
large chuck
The large chuck will close to approximately 12.5mm without collets. With the collets like shown in the pic you can get down to very small diameters because you can increase the wall thickness of the collet. Hope this clears it up.
The large chuck will close to approximately 12.5mm without collets. With the collets like shown in the pic you can get down to very small diameters because you can increase the wall thickness of the collet. Hope this clears it up.
