18 shafts..........

BarenbruggeCues

BarenbruggeCues

Unregistered User
Silver Member
I'll call these B... B+ grade....may have some sugar marks, a birds eye, low ring count and/or some other small aesthetic thing going on. Some of this MAY still cut out when @ finish size.
Overall, they have a good tone, straight grained and would make a good break shaft and/or sneaky style cue shaft.
approx 30" long
.552 @ the tip
.048 larger @ the mid point (15" from the tip .600)
joint end is .875 and a straight barrel for approx 2"
The lightest one weighs 120 grams at this size....some over 125....some over 130

These shafts have been in my shop for well over 10 years. I cut about .025 total dia off these a couple months ago and just checked them today. If they weren't running dead nuts between centers I culled them out. I keep my shop between 70-80 degrees and 45-50% rh all year long.

Need them cut closer to finish size? For a little extra $... LMK
I'll ship them for $350 lower 48.
PPFF or Zelle
Any questions... ask away. PM only

Dy0ijRd.jpg


khT7OuH.jpg


kknsjJv.jpg
 
Last edited:
10 yr old + shafts slow cut to size over the same period of time. These are straight and stable. Just not the aesthetic looking pieces of wood for high end cues. Look at the pictures close. You are looking at the worst side of these shafts. These are not "light in weight" rejects.
Most of these should finish out around 3.7-3.8 +- depending on the final 13mm taper and could be a lot heavier if you build a cue joint with an insert in the shaft.
$340 shipped lower 48
 
You must log in or register to reply here.
Back
Top