1) The one with the wrap.
It had a visibly bent shaft when I purchased it so I made a new one. When it was almost done I forgot to support the joint end when doing the tip and it wobbled and smacked the lathe so there are a few "dings" about 4-6" up from the joint but they do not affect playability. The shaft has a fairly straight taper, I built it for breaking. It does not have a tip on it, I'm out of tips. Shaft is straight, butt has a very slight roll to it. The butt cap has a few dings but the forearm does not.
$SOLD.
Dimensions:
Tip: 13mm
Joint: .84
Butt: 1.25
Weight:
Butt: 16oz
Shaft: 4.18
2) Sneaky
I'm sure it was a bar cue somewhere so there some dings in the butt. I just cleaned up the shaft and waxed it. Unknown tip.
Dimensions:
Tip: 12.2 - pro-taper
Joint: .84
Butt: 1.2"
Weight:
Butt: 14oz
Shaft: 3.7oz
$SOLD
Venmo preferred but PayPal G&S is ok, split the fees.
It had a visibly bent shaft when I purchased it so I made a new one. When it was almost done I forgot to support the joint end when doing the tip and it wobbled and smacked the lathe so there are a few "dings" about 4-6" up from the joint but they do not affect playability. The shaft has a fairly straight taper, I built it for breaking. It does not have a tip on it, I'm out of tips. Shaft is straight, butt has a very slight roll to it. The butt cap has a few dings but the forearm does not.
$SOLD.
Dimensions:
Tip: 13mm
Joint: .84
Butt: 1.25
Weight:
Butt: 16oz
Shaft: 4.18
2) Sneaky
I'm sure it was a bar cue somewhere so there some dings in the butt. I just cleaned up the shaft and waxed it. Unknown tip.
Dimensions:
Tip: 12.2 - pro-taper
Joint: .84
Butt: 1.2"
Weight:
Butt: 14oz
Shaft: 3.7oz
$SOLD
Venmo preferred but PayPal G&S is ok, split the fees.
Last edited: