3/8 11 pin

[Busbee Cue]

Hello,

I am looking for a 3/8 11 titanium joint screw. Do any of you good folks make these? Prather discontinued them because of cost and replaced them with G10, is this as strong? Any info would be appreciated. Thank you.

 

[rhncue]

Hello,

I am looking for a 3/8 11 titanium joint screw. Do any of you good folks make these? Prather discontinued them because of cost and replaced them with G10, is this as strong? Any info would be appreciated. Thank you.

Is a G10 pin as strong as a titanium or other metal screw? Absolutely not. However they are probably more than strong enough for a cue stick. If enough pressure is put on a G10 it is going to break but this same amount of pressure will either bend a metal pin or break the cues shaft or butt.

Dick