I will have my smart table recovered in the near future.I'm thinking I can pull this off myself
with y'all's help and some online videos,
however I would definitely consider a reputable diamond mechanic.(only if I can watch)ha,ha.
I don't know any in my area between Baton Rouge and NOLA.
My table is in a well insulated (but not well ventilated at the moment) metal building.
It has adequate climate control but only when I'm in there.Humidity is sometimes an issue.
Ok,here are some questions
I'm undecided on cloth.
Simons 860 or 860 HR. I understand HR is faster but should I consider it for durability also.(and maybe humidity) ?
Any advice on good pricing for cloth and glue?
Do any of you know of any videos for Diamond rails?
Staples:I assume all old staples should be removed.Is there a certain size that works best.?
Can I use my 18ga.1/4" Pneumatic Senco? 1/2" is the shortest staples it will use.Is 1/2" too long.
Also I think these might be difficult to remove for the next re-cover.
Thanks in advance
Mike L.
I'm sure more questions will arise later.
with y'all's help and some online videos,
however I would definitely consider a reputable diamond mechanic.(only if I can watch)ha,ha.
I don't know any in my area between Baton Rouge and NOLA.
My table is in a well insulated (but not well ventilated at the moment) metal building.
It has adequate climate control but only when I'm in there.Humidity is sometimes an issue.
Ok,here are some questions
I'm undecided on cloth.
Simons 860 or 860 HR. I understand HR is faster but should I consider it for durability also.(and maybe humidity) ?
Any advice on good pricing for cloth and glue?
Do any of you know of any videos for Diamond rails?
Staples:I assume all old staples should be removed.Is there a certain size that works best.?
Can I use my 18ga.1/4" Pneumatic Senco? 1/2" is the shortest staples it will use.Is 1/2" too long.
Also I think these might be difficult to remove for the next re-cover.
Thanks in advance
Mike L.
I'm sure more questions will arise later.
