Hi again all, I just accquired an 8' Global coin op Challenger table. I have some new Ridgeback rails being made for it. While talking to Kerry, he asked if it had any cabinet sag. I checked it out and it appears there is none. He said that if there was, I could add some extra support under the middle of the cabinet. If there is no sag now, is there likely to be any in the future? This table is out in my shop with no temperature or humidity control yet. I'm thinking of contacting Global and getting two factory legs and placing them underneath the center edges while the slate is off/up. Is this a good idea or neccessary? Now would be a good time to do the new leg T nuts while the table is apart. Also I'm going to place a heater inside table to help keep moisture out. I'm trying to make this table the best it can be with what I have. Any input from you would be deeply appreciated.