A few almost done...

Zims Rack

Promoting the Cueing Arts
Silver Member
Here's a few cues that I'm about done with.
Still need joint collars, final cut, install 3/8-10 joint pin, spray and install wraps.

1) 8 Points, 4 high bacote, 4 low ebony into b-eye forearm, double brass surrounded by black rings at all locations, bacote butt sleeve with an ebony ring in middle, black phenolic butt cap and joint collars.
... will have 2 shafts w/matching rings, textured black leather wrap.

2) 8 Points, 4 high ebony, 4 low ebony with red and black veneers into b-eye forearm, black/red slotted ring surrounded by red and black rings at all locations, b-eye butt sleeve with an ebony ring in middle, black phenolic butt cap and joint collars.
... will have 2 shafts w/matching rings, textured black leather wrap.

3) 6 Point, 3 high/3 low ebony points with maple veneer into tulipwood forearm, black/white slotted ring surrounded by white and black rings at all locations, ebony butt sleeve, black phenolic butt cap and joint collars.
... will have 3 shafts w/matching rings and linen wrap. SOLD!

Just thought I'd share!
Zim
 

Attachments

  • ZCCInProcessSep16a.JPG
    ZCCInProcessSep16a.JPG
    35.4 KB · Views: 193
  • ZCCInProcessSep16b.JPG
    ZCCInProcessSep16b.JPG
    43.9 KB · Views: 156
  • ZCCInProcessSep16c.JPG
    ZCCInProcessSep16c.JPG
    51.5 KB · Views: 150
Last edited:
Back
Top