I have had a B cue shaft(name?) for a few years now that is suppose to be 3/8 10 I have been using it on a Singapore Sawdust cue that is also suppose to be 3/8 10, however I was checking tonight out of curiosity what the fit was like. to preface I haven't played a lot in the last 4 years neck fusion and shoulder replacement. when I checked the fit I noticed the fit was a little loose with the B cue shaft. However, my question is how would this shaft fit and work with a 3/8 10 modified? and if not at all can most cue guys be able to take this Italian shaft and make it work with a 3/8 10. The reason for the question is that I want to try out a Viking Cue with a modified 3/8 10 pin.
TIA
please don't bad too hard again haven't played in a minute.
TIA
please don't bad too hard again haven't played in a minute.
Last edited: