Not for 'Art cases'. But for my regular, throw in the trunk case just copy the logo in the upper left hand corner of this page on paper, cut it out and
glue it to a flat surface of you case. To protect it give it a couple coats of polyurethane.
I went one step further and copied to transfer paper (mirror image), ironed it on to the clean area of an old T-shirt ,cut it out and glued itto the lid of my case.Then urethaned it. I liked using the cotton material because you can stretch it over rounded areas.
This will do until an official version comes out.
glue it to a flat surface of you case. To protect it give it a couple coats of polyurethane.
I went one step further and copied to transfer paper (mirror image), ironed it on to the clean area of an old T-shirt ,cut it out and glued itto the lid of my case.Then urethaned it. I liked using the cotton material because you can stretch it over rounded areas.
This will do until an official version comes out.
