BobCad 26 or 27 Nesting

Guerra Cues

Guerra Cues

I build one cue at a time
Silver Member
Hi folks,

I was wondering if any of the fellow cuemakers here are using BobCad 26 or 27 version, It has to be these versions since there are significant changes from older BobCad builds.
I just have a few questions because I have to end up editing the gcode on parameters I did not ask for. I am sure I am doing something wrong...:angry: My phone is 209-482-7768.
 
Guerra Cues said:
I've seen that but some of the parameters I'm entering must not be right. I will get it figured out.
Click to expand...
camtree, select nesting then select your geometry then go through your parameters ...sheet size, ## of parts keep your head in the computer it takes time it's the only way you"re going to learn.
 
leon sly said:
camtree, select nesting then select your geometry then go through your parameters ...sheet size, ## of parts keep your head in the computer it takes time it's the only way you"re going to learn.
Click to expand...


Yep. Got it figured out. It was just throwing some weird numbers and Bobcad told me where the issue was.
 
You must log in or register to reply here.
Back
Top