brass insert needed

[nympfisher]

anyone close to north Carolina have a single brass insert that is 7/16 -14 that will sell me. I have plenty of the standard ones, but not this one, someone drilled the threads out to make it a quicker release. and no it wasn't I ..

thanks , carl

 

[nympfisher]

these seem to be a bit longer too. 1.210 and .472 dia. compared to .450 in the standards I have.

 

[KJ Cues]

My day is done so I've got a min. or two for you.
7/16x14 is generally the dia. and pitch of the OD threads of a std insert.
There is no insert with a 7/16x14 ID.

The other numbers you gave, 1.21"L x .472"D are also cause for concern.
1.21" is not a std insert length and .472" is 12mm.
Could you be persuaded to divulge the brand of cue?
A pic would be wonderful. Would this by chance happen to be a FURY cue???

KJ

 

[nympfisher]

it is a Viking, I measured it with digital calipers and those are the specs . I will double check the tread pitch when I get to work this morning with a thread guage. I saw some at atlas with this thread pitch so I assumed it was 14. all of mine are the 20's and smaller dia.

thanks , carl

 

[KJ Cues]

The Viking QR pin is 5/16x18.
Run a 17/64" drill through the std insert and it will fit the Viking pin.

KJ

 

[nympfisher]

I have standard inserts. This one is bigger. The thread pitch is 14. But I cannot find a die to fit it to confirm. Maybe its a custom made one. The 12 -1.75 is close but pitch is off.
This is a strange one.
Thanks for the advise though.
Carl