Carbide sanding mandrel question

[JA062669]

Looking into purchasing carbide sanding mandrel for Radial & Uni-loc
My question is the finish sizes as follows?
Radial .842 & uni-loc .840? If so where would your sanding sizes be?
Looking at unique products & cue fits. Any suggestions on either.

 

[Michael Webb]

Looking into purchasing carbide sanding mandrel for Radial & Uni-loc
My question is the finish sizes as follows?
Radial .842 & uni-loc .840? If so where would your sanding sizes be?
Looking at unique products & cue fits. Any suggestions on either.

How thick do you plan on your finish being is the real question.

 

[JA062669]

New to this so I'm not sure. That's why I'm asking.

 

[Michael Webb]

New to this so I'm not sure. That's why I'm asking.

Ok
Break down your finishing method.
Do you know yet?

 

[JA062669]

Using auto clear.

 

[cueman]

Looking into purchasing carbide sanding mandrel for Radial & Uni-loc
My question is the finish sizes as follows?
Radial .842 & uni-loc .840? If so where would your sanding sizes be?
Looking at unique products & cue fits. Any suggestions on either.

I started out using sanding size .005 under and then decided I would make my finish .010" total and quit using a sanding set. Just the final size finish set. Save the hundred of dollars and just get final finish size.

 

[JA062669]

Ok. Am I right as far as .842 is standard for like the predator revo radial pin cues?

 

[Michael Webb]

Ok. Am I right as far as .842 is standard for like the predator revo radial pin cues?

Yes .842 on everything is great.