Hello everyone, still fairly new to the forum and I am hoping to get some direction on moving to CNC for inlays.
I have looked at the Taig style and it seems I can get into it for about 4-5k for the 4-Axis? Long term is that the way to go? Then I read about units that use routers for cutters, ball drive vs screw.
Also without going back to school for computer programing is that a good intuitive program that will allow good operation for the learning curve of cue inlay progression?
I am a basement builder and I make about 30 cues a year. I have learned alot from you folks just reading the posts. :thumbup:
Thanks
Dick D.
I have looked at the Taig style and it seems I can get into it for about 4-5k for the 4-Axis? Long term is that the way to go? Then I read about units that use routers for cutters, ball drive vs screw.
Also without going back to school for computer programing is that a good intuitive program that will allow good operation for the learning curve of cue inlay progression?
I am a basement builder and I make about 30 cues a year. I have learned alot from you folks just reading the posts. :thumbup:
Thanks
Dick D.