Hello, I have an old Huebler Mark 2 butt that was salvaged from a 1 piece cue. Current length is 33” where it was cut off. I’m looking for a cue maker that can cut it off flush and insert a 5/16 x 18 pin.
I’m wanting it cut off wherever it is at .835 in thickness to match my carbon fiber shaft. This would be approximately at 30 5/8” in length. I was hoping for a 31” length, but this is close enough. Can anyone recommend a cue maker anywhere in Arizona, southern Nevada, or southern California that could do this? I would prefer to drop off the butt and shaft in stead of shipping it. No refinishing needed. Thanks
I’m wanting it cut off wherever it is at .835 in thickness to match my carbon fiber shaft. This would be approximately at 30 5/8” in length. I was hoping for a 31” length, but this is close enough. Can anyone recommend a cue maker anywhere in Arizona, southern Nevada, or southern California that could do this? I would prefer to drop off the butt and shaft in stead of shipping it. No refinishing needed. Thanks
