This is a cue built by the well known maker here, New Sheriff. Great figuring in the maple with copper ring work, abalone dot inlays and a copper joint pin. A pebbled leather wrap finishes it off beautifully.
Below are the specs from the original F/S post:
Butt 29"
Shaft 29"
Total 58"
Butt 15oz
Shaft 3.4oz
Total 18.4oz Can go lighter not heavier if needed
Joint 3/8-10 mod copper pin
Balance 17 3/4 from bottom of butt cap
Joint dia .840
Butt dia 1.210
Tip 13mm triangle
In addition to the original shaft, I am including a Joss Natural LD shaft.
Great cue, I just haven’t used it much so passing it on.
Both shafts roll straight but there is some movement when rolling the butt so when assembled and rolled there is some movement.
The whole setup for $450 shipped.
Questions? Just ask.
Below are the specs from the original F/S post:
Butt 29"
Shaft 29"
Total 58"
Butt 15oz
Shaft 3.4oz
Total 18.4oz Can go lighter not heavier if needed
Joint 3/8-10 mod copper pin
Balance 17 3/4 from bottom of butt cap
Joint dia .840
Butt dia 1.210
Tip 13mm triangle
In addition to the original shaft, I am including a Joss Natural LD shaft.
Great cue, I just haven’t used it much so passing it on.
Both shafts roll straight but there is some movement when rolling the butt so when assembled and rolled there is some movement.
The whole setup for $450 shipped.
Questions? Just ask.
Last edited: