Whats the least expensive engraver for lets say engraving thr RD logo in butt caps
Engraver Suggestions for Simple Letter Based Logo
- Thread starter RDCustomCues
- Start date
Logos
I am not sure about engravers, but I would make my logo in ILLUSTRATOR, in 3D. Then print it on a water transfer decal. Seal it, and the visual result is the same--no fuss and a lot cheaper for the same results.
Bob Flynn
www.denalicues.com
RDCustomCues said:
I am not sure about engravers, but I would make my logo in ILLUSTRATOR, in 3D. Then print it on a water transfer decal. Seal it, and the visual result is the same--no fuss and a lot cheaper for the same results.
Bob Flynn
www.denalicues.com
Hmm wonder what Chris Hightower uses