Ok, trust me when I tell you that it KILLS me to do this. The only reason I am doing this is I have 2 bigger cues coming in, and these shafts would just sit in my case, so off they go into AZ land. :sorry:
I bought these shafts years ago and literally centered all of my cues around these shafts. I only used one shaft (the top shaft was my primary player; the other one, literally, was tested one time)
The shafts have nice grain patterns to them. They hit better than most cue shafts I have played with. Here is the pertinent information:
JOINT COLLAR: BLACK PHENOLIC.
JOINT SIZE-5-16X14
FERRULES: IVORY
TIPS: BOTH MOORI MEDIUMS (THE OLD MORRI III'S)
MEASUREMENTS:
A-TOP SHAFT: 4.3 oz (I don't have a digital scale, but my food scale measures around that)12.42 mm @ the top of the ferrule, 0.828 inches @ the collar. THE TAPER HITS 13.02MM ABOUT 14 1/2 INCHES FROM THE FERRULE.
B-BOTTOM SHAFT (NOT USED BY ME EXCEPT TO TEST ONE TIME):4.3 oz (roughly) 12.45 mm @ the top of the ferrule, 0.830 inches @ the collar. THE TAPER HITS 13MM @ ABOUT 14 3/4 INCHES FROM THE FERRULE.
Both shafts roll straight! There are no dings or dents whatsoever and the shafts have never been sanded or altered in any way. They fit flush with
Asking $OLD!!!
PM me please with any questions. Thanks for looking and have a great day!
I bought these shafts years ago and literally centered all of my cues around these shafts. I only used one shaft (the top shaft was my primary player; the other one, literally, was tested one time)
The shafts have nice grain patterns to them. They hit better than most cue shafts I have played with. Here is the pertinent information:
JOINT COLLAR: BLACK PHENOLIC.
JOINT SIZE-5-16X14
FERRULES: IVORY
TIPS: BOTH MOORI MEDIUMS (THE OLD MORRI III'S)
MEASUREMENTS:
A-TOP SHAFT: 4.3 oz (I don't have a digital scale, but my food scale measures around that)12.42 mm @ the top of the ferrule, 0.828 inches @ the collar. THE TAPER HITS 13.02MM ABOUT 14 1/2 INCHES FROM THE FERRULE.
B-BOTTOM SHAFT (NOT USED BY ME EXCEPT TO TEST ONE TIME):4.3 oz (roughly) 12.45 mm @ the top of the ferrule, 0.830 inches @ the collar. THE TAPER HITS 13MM @ ABOUT 14 3/4 INCHES FROM THE FERRULE.
Both shafts roll straight! There are no dings or dents whatsoever and the shafts have never been sanded or altered in any way. They fit flush with
Asking $OLD!!!
PM me please with any questions. Thanks for looking and have a great day!
Attachments
Last edited:
