Falcon cue with a Radial pin?

[BillPorter]

I just won an auction for this cue on eBay: http://cgi.ebay.com/ws/eBayISAPI.dl...50018745135&rd=1&sspagename=STRK:MEWA:IT&rd=1

Although it says "radial joint pin," I am wondering if my OB-1 shaft for a Radial pin will fit. I know that there are at least two "flavors" of Radial pins, and just read in a thread on this forum about 3/8 by 7.5 vs. 3/8 by 8. Any thoughts? Thanks in advance.

 

[Mase]

I just won an auction for this cue on eBay: http://cgi.ebay.com/ws/eBayISAPI.dl...50018745135&rd=1&sspagename=STRK:MEWA:IT&rd=1

Although it says "radial joint pin," I am wondering if my OB-1 shaft for a Radial pin will fit. I know that there are at least two "flavors" of Radial pins, and just read in a thread on this forum about 3/8 by 7.5 vs. 3/8 by 8. Any thoughts? Thanks in advance.

It is the same pin used in Predator cues.

Edit. I misinformed you. For some reason I was thinking uniloc and they had a line of cues with them. I have not seen a falcon with a radial. They used to make them with 3/8 x 10. I am not sure what radial pin it would be.