For Sale

boba_fett23

boba_fett23

AzB Silver Member
Silver Member
All SOLD.....thanks

I am selling:

Mcdermott; $125 (1) I-2 shaft, fair amount of use good condition, straight.
$175 (1) I-3 shaft, used twice great condition, straight.
both shafts Mcdermott joint 3/8 x 10 with single gold ring.
Both shaft were additionally bought from Mcdermott Cues.

Mcdermott Hustler cue (Sneaky M1-1B) $225 used hand full of times bought in 05 good condition.

Mcdermott Warden Cue (M1-1A) $250 Cue was bought new in 06, good conditon.

$180 (1) 30" Predator 314-2 shaft with moori Medium tip 5/16 x 14 joint with single silver ring, like new condition.

$150 (1) Predator Z shaft. Purchased new and used twice. Radial pin joint Solid black.

$75 (1) Muecci Black dot shaft for Muecci joint with single silver ring.

Will also accept offers, possible trade for right Schon cue

Please email or PM for pics if interested.

Thanks
 
Last edited:
Good Luck

I have been lookin to try an i2 or i3 shaft but McDermott and any I have seen selling them are a bit too proud.

I only pop in here because I was looking for an i-2 shaft for my McDermotts (I have a QR jointed M14 Sentinel and a D-16/P702 splice point with 3/8-10) and I found a brand new OB-1 for 120 shipped on fleabay and I picked up a used Z-2 for 100.

Can you give any opinion / comparison to the i shafts compared to OB-1 or 314 / Zshafts?

Thanks and Good luck with your sales
 
I downloaded a Deflection Ratings chart at Platinum Billiards.com site. A robot is used that produces cue ball speeds of around 15 mph and deflection noted at 50" (distance from foot string to head spot on a 4 1/2x9 table. One column posts deflection over 50" on a series of shafts. The least deflection, according to the chart, is Predator Z-2 with 29.6 mm. The 314-2 is 33.0 mm. OB-1 is 33.4, McDermott I-3 is 36.8, McDermott I-2 is 38.6, Mcdermott I-1 is 39.6, and a regurlar McDermott shaft is 42.9. An inch is 25.4 mm so you can see that the differences are fairly small. Hope this helps.
 
I now play with a Pred 2K4 with Z2 shaft/314 shaft. The Z2 and the I-3 are similar (Euro Taper and 11.75) and the I-2 shaft is comparible with the 314 and OB-1 (Pro taper and 12.75). I thinks as far as the deflection is concerned they are very close if not right on par with the comparibles. My first cue was a Mcdermott, so that is how I ended up purchasing the addtional aftermarket shafts. The I series shaft hit good and have a good feel. To me they feel a little on the light side. I dont use them so I am selling them for a decent price seemings they retail for well over $200.
 
You must log in or register to reply here.
Back
Top