FS: Mezz Pool Cue - ZZ-SP

PROG8R

Gator Nation
Silver Member
The PIC below is the model, but not the actual cue.
It is dead nuts straight, Mike Gulyassy just put a brand new Kamui Black SS on it and cleaned up the shaft a bit. It has been played with for a few hours since then. It has the WD-700 shaft. There are four (I have not inspected it too much) dings in the finish near the butt. I love the balance and hit of the cue. It is just close to Christmas. I will try to get PICS up later. Comes with joint protectors.
View attachment 161849

$220.00 shipped CONUS only.
 
Last edited:
Almost time for bed bump.

Also selling off golf equipment to help downpayment for SW that is almost done. PM for info Prices are sick low for some juiced up ping drivers, vokey spin mill, tp. mills, BB 3w, etc...
 
Instead of adding pics. (I need batteries for my camera).

Here is link to the cue with pics from when I bought it. It also has a better description.

You can just make out one of the dings in the pic of the butt. I added one just like it from the edge of the table very near the same spot.

http://forums.azbilliards.com/showthread.php?t=180329
 
Last edited:
I just got back from the pool hall. After another inspection I noticed that there were 4 dings near the butt. It isnt into the wood, just the finish and will in no way effect play. I did want to point that out. They are not really noticable, but they are there and hell a cue inst a beauty show it is about playability and this is one bad ass player for 220.00, The shafts are going for 150 on here anyways.
 
Back
Top