FS: Two Shafts: Tascarella - Richard Black

[lcbur]

1. Tascarella? NO. My mistake It is a Rick Howard Shaft on bottom with red ladder ring work: Joint collar .828" 29" shaft - 13.2mm - 3.98 oz.
2. Richard Black on top with silver ring - ivory ferrule. Joint collar .827": 29" shaft - 12.75mm - 3.83 oz.
Both Shafts are straighter than an arrow is supposed to be. They both roll perefectly flat. The Black is 5/16 x 14 thread. I am not sure what thread Rick Howard uses. I think it is 3/8 x11. They are both perfectly smooth ( no dings )
Rick Howard: Unhit new condition shaft - $145. Shipped
Richard Black Shaft - SOLD Shipped

 

[Scratch]

is the Tasc 3/8-11?

 

[lcbur]

shaft 3/8 x 11?

Probably is 3/8 x 11 : It is 3/8 but won't take a 3/8 x 10 pin which I have. I don't have a 3/8 x 11 pin to check it. What ever standard pin Tascarella uses is what it is. Whoever needs a Tascarella shaft will know the thread they use.

 

[Bob Farr]

1. Tascarella on bottom with red ladder ring work: 29" - 13.2mm - 3.98 oz.
2. Richard Black on top with silver ring.: 29" - 12.75mm - 3.83 oz.
Both Shafts are straighter than an arrow is supposed to be. They roll perefectly flat. The Black is 5/16 x 14 thread. I am not sure what thread Tascarella uses. Not 3/8x10 but close. They are both perfectly smooth ( no dings )
Tascarella Unhit new condition shaft - $185. Shipped
Richard Black Shaft - $130. Shipped

Can you measure the collar on the Black shaft? If it's around .835" I'll take it.

 

[lcbur]

Tascarella Shaft

Tascarella Shaft Still here