GC4 Rail Bolts

[CGM]

What is the correct rail bolt that bolts through the slate into the rail of a GC4? The table i just bought has a frankenstein of different rail bolts and studs.

 

[Lawnboy77]

Stud is 3/8-16 X 2-3/4” with 3/8”-16 nut, and don’t forget the domed washer.

Trent just posted this in the other thread about “GC4 Disassembly”. Brunswick is pretty good about specifying hardware specs.


Sent from my iPhone using Tapatalk

 

[Sheldon]

Crown Lock Washer

Use these crown lock washers (3/8" diameter) to help keep your table's rails tight and maintain proper tension of rail bolts to give consistent and accurate play. Sold individually.

www.muellers.com

Only .35 each if you have a "wholesale" account.

 

[Hinekanman]

Crown Lock Washer

Use these crown lock washers (3/8" diameter) to help keep your table's rails tight and maintain proper tension of rail bolts to give consistent and accurate play. Sold individually.

www.muellers.com

Damn wish I would have seen this. Which reminds me. Where is my order.


Sent from my iPhone using AzBilliards Forums

 

[trentfromtoledo]

What is the correct rail bolt that bolts through the slate into the rail of a GC4? The table i just bought has a frankenstein of different rail bolts and studs.

they use a stud, nut and dome washer combo from the factory, when you do have those, its easiest to put the studs in the rails while the top is upside down, then nut and dome washer once the top is on! or just replace with regular style bolts. good luck!

TFT