Huebler rubber bumper and weight bolt

[Newton]

I have a new customer which has a old custom Huebler which has a damaged bumper. He would also like to change the weight.

The cue is out of reach for me but remembering from my younger days-these cues had a very nice brown soft bumper which made that special nice sound when touching the floor.
Is there some of you which could point me to a source on these bumpers where I would order some to keep in stock?

Also, I remember the weight bolt was threaded in the back with a small screw to hold the bumper but have no idea on thread sizes.
If some one could help me out with a source (or thread sizes) on these-it would be highly appreciated.

PM me if this is prefered (I'm low on space up here but would try to clean up)

Thanks

Kent

 

[ratcues]

The bumpers are proprietary to Huebler. I used to have a handful but now I only have a couple. I can send you one with the cap screw.

The weight bolts are usually glued in and hold the flat-faced butt cap to the butt sleeve. 3/8-16 with the 8-32 tapped for the bumper's cap screw.

 

[Newton]

The bumpers are proprietary to Huebler. I used to have a handful but now I only have a couple. I can send you one with the cap screw.

The weight bolts are usually glued in and hold the flat-faced butt cap to the butt sleeve. 3/8-16 with the 8-32 tapped for the bumper's cap screw.

That would be great Ryan if you could help me out with that bumper I have so far not seen the cue-but I think this is the "normal" looking ones-not the "Hoppe" style. If you could just add this in the package with the cue your working at for me-that would be fantastic.
Let me know what I owe you in case and just add it to the rest of my bill.

I would have a look at the cue asap and check out the weight bolt and see if some of my stock ones would do.

Thanks a bunch.

Kent