If you own a Dennis Swift cue case please answer a couple of questions

[cueballfoul]

I was looking at Swift's new web-site, and there are no photos of the insides of his cases. Does he use tubes or a soft dividers for butt & shaft sections. Is the inside of the case top padded?
I also wonder with a Swift Case can you put butt, or shaft sections in a Swift case in either direction, also do the butt & shaft fit fairly snug, or do they fit sloppy. Where the butt section rattle around like some of the cheap import tube cases.

 

[Scottster]

I was looking at Swift's new web-site, and there are no photos of the insides of his cases. Does he use tubes or a soft dividers for butt & shaft sections. Is the inside of the case top padded?
I also wonder with a Swift Case can you put butt, or shaft sections in a Swift case in either direction, also do the butt & shaft fit fairly snug, or do they fit sloppy. Where the butt section rattle around like some of the cheap import tube cases.

I have a 3x6 Swift I use as my everyday case. The inside is made of tubing lined in a red felt. I put my cues in the case with the pin facing up. I use some hard foam inserts around the top of the cue to prevent any rattling of the cues inside the case. I also fold up a small soft towell and put it in the lid for extra padding and also use to wipe the cue's down before putting back in the case.

Hope this helps,

Scott

 

[CocoboloCowboy]

Have you tried e-mailing Dennis with your questions?