Jerry Rauenzahn Ebony/Black Four Solid Points -R- Custom Cue
Jerry build the cue for me in 2019. The cue is in very good used condition. It has been played with and shows some minor scuffs and dings to the butt. The shaft was only test hit, since a performance shaft was paired with the cue for play which is not included in this listing.
Asking $1000. Accept Zelle or PayPal (friends and family).
I will cover the shipping cost, via USPS Ground Advantage, inside the lower 48 US States; no international.
Buyer must have positive iTrader feedback to purchase.
I will ignore messages from new accounts with limited account/posting history.
Jerry build the cue for me in 2019. The cue is in very good used condition. It has been played with and shows some minor scuffs and dings to the butt. The shaft was only test hit, since a performance shaft was paired with the cue for play which is not included in this listing.
- Feel: There is a slightly raised edge where the butt sleeve meets the wrap. It is visible upon close inspection, but don't feel its noticeable once you begin playing.
- Roll: The cue rolls straight and hits with the classic "forward balanced - stiff but responsive" feel Rauenzahn is famous for. The shaft has a minor taper roll.
- Total Length: Approximately 58" (standard)
- Butt Weight: 15.8 oz
- Shaft Weight:3.8 oz
- Total Weight: Combined scale weight shows ~19.6 oz (1 lb 3.8 oz). Due to scale variance, total weight is approximately 19.6 - 19.7 oz.
NOTE: There is a short plastic weight bolt installed which is just holding the bumper in. I've included three more weight bolts to bring the weight up by 0.1oz (picture in album (see link below) shows 0oz but my scale doesn't show 0.1 increments), a 0.2oz, and 0.4oz. I also included another bumper.
- Total Weight: Combined scale weight shows ~19.6 oz (1 lb 3.8 oz). Due to scale variance, total weight is approximately 19.6 - 19.7 oz.
- Tip Diameter: 13.06 mm (measured via digital caliper)
- Tip Type: Triangle
- Joint Diameter: 0.840" (measured via digital caliper)
- Joint Type: 5/16-14 (shaft has piloted insert)
- Balance Point: Approximately 19 5/8" from bumper
- Joint Protectors: Included
Asking $1000. Accept Zelle or PayPal (friends and family).
I will cover the shipping cost, via USPS Ground Advantage, inside the lower 48 US States; no international.
Buyer must have positive iTrader feedback to purchase.
I will ignore messages from new accounts with limited account/posting history.
Attachments
Last edited: