Looking for Rebco pockets

Sheldon

Sheldon

dontneednostinkintitle
Silver Member
Looking for 2 pockets for an old Rebco with a ball return. The bottom of the pocket has an weird twist to it to feed the ball into the return so they are specific to each side of the table. (left and right)

xHli87Z.jpg
 
If you cant find pockets specifically for your table maybe check a Gold Crown pocket, my GCI has left and right hand pockets to line the ball up with the gully.
 
Sheldon said:
Looking for 2 pockets for an old Rebco with a ball return. The bottom of the pocket has an weird twist to it to feed the ball into the return so they are specific to each side of the table. (left and right)

xHli87Z.jpg
Click to expand...

That's a great table! I have one just like it, except mine doesn't have the ball return. I love it.
I also have a Gold Crown I and in terms of build quality, l'd say they are equal.

Anyway, Bob Bebb of Rebco, built that table, I spoke to him about 2 months ago, he's still restoring and building tables he'll have what you need or tell you where to get it.

I'm pretty sure the pockets are identical to my GCI, in fact, I put my old GCI pockets in the Rebco, then bought a new set for the GCI. Mine are drop pockets, but I bet the GCI ball return pockets will fit your table.

If you crawl under the table and snap a photo of the serial number, then send him a photo of the table and number, he'll tell who he made the table for. Most of that model were built for pool halls.

Good luck
 
Last ditch chance when all the obvious sources are depleted:

Some smart kid at your local library can probably scan and crank a couple out on one of the 3D printers. You pay resin/filament cost.

:grin:

If your state does not have shops with cnc machines in the libraries, try a maker space.

smt
 
You must log in or register to reply here.
Back
Top