REDUCED TO $350 shipped to the US.
This cue is made from a Predator/Falcon sneaky pete blank that was sold on here by Duc Lam (sp?) some years back. The forearm is lightly figured birdseye maple. Both the joint collar and butt cap are made of deer antler.
The cue weighs 18 ounces (can be increased or decreased a little) with a neutral balance point of about 18.7 inches from the back of the cue. The shaft is straight grained with around 16 growth rings per inch and weighs 3.7 ounces at 12.6 mm. The ferrule is ivorine III, medium Molavia tip installed.
Joint pin is brass 3/8-10 FB pin.
A couple of the point tips are not fully sharp due to tear out. Thanks for looking.
http://mvpcues.com/cuesforsale.php
This cue is made from a Predator/Falcon sneaky pete blank that was sold on here by Duc Lam (sp?) some years back. The forearm is lightly figured birdseye maple. Both the joint collar and butt cap are made of deer antler.
The cue weighs 18 ounces (can be increased or decreased a little) with a neutral balance point of about 18.7 inches from the back of the cue. The shaft is straight grained with around 16 growth rings per inch and weighs 3.7 ounces at 12.6 mm. The ferrule is ivorine III, medium Molavia tip installed.
Joint pin is brass 3/8-10 FB pin.
A couple of the point tips are not fully sharp due to tear out. Thanks for looking.
http://mvpcues.com/cuesforsale.php
Last edited:
